User Manual

TrackerPAL™ Operations Guide

RemoteMDx, Inc.

Page 11

Scenario A:

1) Execute Power Off command from the Gateway Interface

2) OTD will reply to acknowledge, and then shutdown a short while later (approximately 5 secs.)

Scenario B:

1) Remove external battery

2) Press Reset button, if present

Scenario C:

1) Remove external battery

2) Wait for device to power off. This is a configurable setting, which defaults to running until the

internal battery is depleted (approximately 2 hours).

4.2 External Battery Replacement

The device will indicate a low external battery charge state with the following:

• an amber Power LED flashing every 5 seconds

• a periodic “Low External Battery” alert sound

• a periodic vibrate

When the external battery is low:

1) Remove the external battery pack by releasing the latch, and sliding it off along the rails.

Device will make “External Battery Removed” alert sound, and transmit an informational

message (configurable).

a) If the external battery pack is not replaced within a configurable time period (default 15

seconds), the device will make an “External Battery Removed Timeout” siren sound.

b) If the external battery pack is still not replaced within a configurable time period (default 30

seconds), the device will send an “External Battery Removed Timeout” alarm message.

c) If the external battery pack is still not replaced within a configurable time interval (default 60

seconds), the device will make an “External Battery Removed Reminder” alert sound, and

continue repeating at the configurable time interval until the battery pack is replaced.

2) Attach a freshly charged external battery pack by following the same instructions in reverse.

Device will make “External Battery Attached” alert sound, and transmit an informational