User's Manual

2. On the beacon, move the power switch to the ON position through the hole in the
back cover.
3. Place the beacon on a horizontal surface like a table or counter top with the back
down on the surface. The ARM switch should be visible facing up.
4. Press and hold the ARM button for 1 to 2 seconds until the LED flashes three
times and then let go.
5. This procedure will command the beacon to enter a test mode where it will send
out three test messages. As each message is transmitted, the LED will blink
green. The “Valentine” bracelet that that is within range will beep. The beep
from the offender tracking bracelet is proof that the wireless transmission was
successful.
6. Pick the beacon up from the table and move the switch to the OFF position
through the hole in the back cover.
7. The beacon is ready to be deployed in the field. Be sure it has fresh batteries
and check to be sure the 3M command adhesive strip is ready to be used.
Replace if necessary.
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications could void the user’s authority to operate the equipment.