Instruction Manual

12
5) Press and hold the network button on the ASR-ZW receiver until it
starts to flash.
3) Now turn the dial until letter E appears in the display.
4) Press the dial once and the display should flash.
1) Turn the dial until the letter P appears in the display.
6) Turn the dial until the letter `I' appears in the display and return to the
main instruction.
2) Press the dial twice and PP should appear in the display.
1) Turn the dial of the HRT4-ZW until the letter P appears in the display.
3) A second P should appear in the display which now shows `PP'.
Stage 2 – Only used if the above procedure does not establish a
successful communication link
Stage 1A – Only used if 'L' is displayed instead of 'I'
4) Turn the dial until the letter 'I' appears in the display and return to the
main instruction.
2) Press the dial twice.
Under normal circumstances the HRT4-ZW thermostat and ASR-ZW
receiver will be 'paired' easily by following the procedure shown under
Stage 1 of the pairing instructions.
Only use Stage 2 if a radio link cannot be successfully established between
the two devices.