Instruction Manual

EXAMPLE: If you turn
the system ON again
after the preset night
shut down time, when
you turn it OFF before
retiring make sure to
operate the advance
switch again until the
number 4 is displayed in
the switch state indicator
so that the red tappet
number 1 will switch the
sy s t e m O N in th e
morning.
5
Switch
State
Indicator
DO NOT OPERATE THE ADVANCE
SWITCH WHEN A TAPPET IS
AGAINST THE TIME LINE.
If the switch state indicator does not agree with the
programme set on the dial, rotate the dial one whole turn
and reset to the correct time of day. This will ensure that
the switch state corresponds to the last tappet
operation.
Switch State Indicator
Eg. If the system was switched ON by tappet 1 at 7:00
am and it is now 9:00am, providing that no further
tappets operations have past, a number 1 should show
in the aperture.
Located above the ADVANCE switch, the switch state
indicator shows you the number of the tappet which
operated last.