User's Manual

Copyright © 2011 P983 X10
BATTERY INSTALLATION & PROGRAMMING PET IMMUNITY TIPS MOUNTING PIR WITH INSTALLATION BRACKETS
MOUNTING PIR WITHOUT INSTALLATION BRACKETS WALK TESTING AND OPERATIONAL TESTING BATTERY REPLACEMENT
SPECIFICATIONS IMPORTANT! REGULATORY STATEMENTS
• The radios are required to comply with Rules and Regulations. As such, they have
limited transmitter power and therefore limited range.
• Changes or modifi cations not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
• A receiver cannot respond to more than one transmitted signal at a time and may
be blocked by radio signals that occur on or near their operating frequencies,
regardless of code settings.
• Infrequently used radio links should be tested regularly to protect against undetected
interference or fault.
• A general knowledge of radio and its vagaries should be gained prior to acting as
a wholesale distributor or dealer, and these facts should be communicated to the
ultimate users.
PRINTER’S INSTRUCTIONS:
INSTR,INSTL,DXS-55AF - FILE NAME: P983 X10 - INK: BLACK - MATERIAL: 20 LB. MEAD BOND - SIZE: 11.000” X 8.500” - SCALE: 1-1 - SIDE 2 OF 2
PET SIZE
JUMPER
15K = 33 LBS.
25K = 55 LBS.
SENSITIVITY
JUMPER
USE LOWEST
SETTING FOR
MAXIMUM
PET WEIGHT
ALWAYS SET
TO LOW FOR
PETS
To take full advantage of the DXS-55AF pet
immunity features in installations with pets, use
these following steps:
• Mount the PIR with the center of the lens 7-1/2
to 8 feet above fl oor level.
• Set the SENSITIVITY jumper to the LOW
position.
• Set the PET SIZE jumper to the lowest setting
for the maximum pet weight.
• Mount the PIR where pets cannot come within
six feet of the unit by climbing on furniture,
boxes, or other objects.
• Do not aim the PIR at stairs or furniture, boxes,
or other objects that can be climbed by pets.
• NOTE: The DXS-55AF will provide immunity
to false alarms for an individual animal or a
group of animals whose total weight is equal
to or less than 55 pounds when the room
temperature is above 50° F and below 90° F.
If the optional mounting bracket is used, it
should be mounted with no tilt.
OBSERVE BATTERY POLARITY!!!
PREPARE THE RECEIVER TO
"LEARN" THE TRANSMITTTER
WHEN THE RECEIVER IS READY,
INSTALL THE CR123A 3-VOLT
LITHIUM BATTERY AS SHOWN
PIR WILL SEND A TRANSMISSION
TO THE RECEIVER AND THE
TRANSMITTER'S ID WILL
BE STORED IN THE RECEIVER
CORNER MOUNTING
WITH CORNER
BRACKET
7.5 FEET
ABOVE THE
FLOOR
7.5 FEET
ABOVE THE
FLOOR
WALL MOUNTING
WITH WALL
BRACKET
ATTACH REAR OF
CASE TO THE
PIR BRACKET
- OR -
SECURE PIR
BRACKET WITH
SCREW AND WASHER
7.5 FEET
ABOVE THE
FLOOR
CORNER MOUNT
REAR CASE WITH
FOUR SCREWS
- OR -
WALL MOUNT
REAR CASE
WITH TWO
SCREWS
PRESS WALK TEST
BUTTON ON LEFT
SIDE OF CASE
RED WALK TEST INDICATOR
WILL SHOW THROUGH PIR LENS
UNIT WILL STAY IN
WALK TEST MODE
FOR THREE MINUTES
WALK ACROSS BEAM PATTERN
WHILE OBSERVING THE
WALK TEST INDICATOR
SNAP CASE
CLOSED BEFORE
WALK TESTING
AFTER WALK TESTING, TEST
THE PIR WITH THE SYSTEM
CONTROL PANEL OR RECEIVER
INSTALL CR123A 3-VOLT
LITHIUM BATTERY AS SHOWN
OBSERVE
BATTERY
POLARITY!!!
WHEN THE SYSTEM INDICATES THAT THE
PIR HAS A LOW BATTERY, REMOVE THE
OLD BATTERY AND DISPOSE OF IT PROPERLY
WARNING!
IMPROPER HANDLING OF LITHIUM
BATTERIES MAY RESULT IN HEAT
GENERATION, EXPLOSION OR FIRE,
WHICH MAY LEAD TO PERSONAL
INJURIES. REPLACE WITH ONLY
TYPE CR123A BATTERY.
WARNING!
BATTERY MUST NOT BE RECHARGED,
DISASSEMBLED, OR DISPOSED OF
IN A FIRE. DISPOSAL OF USED BATTERIES
MUST BE MADE IN ACCORDANCE WITH THE
WASTE RECOVERY AND RECYCLING
REGULATIONS IN YOUR AREA.
OUTPUTS: ALARM, LOW BATTERY, & STATUS
TRANSMITTER FREQUENCY: 315 MHz
UNIQUE ID CODES: OVER ONE MILLION CODES
SUPERVISORY INTERVAL: 70 MINUTES
SENSOR TYPE: QUAD ELEMENT
PET IMMUNITY: SELECTABLE: 15 Kg (33 LBS.) OR 25 Kg (55 LBS.)
SENSITIVITY JUMPER: SELECTABLE: HIGH OR LOW
SUGGESTED MOUNTING HEIGHT: 7.5 FT. (2.3 m)
SENSOR RANGE: 30 FT. (9.1 m) X 50 FT. (15.2 m)
MAXIMUM HORIZONTAL SENSING ANGLE: 86°
DIMENSIONS: 3.2” x 2.5” x 1.9” (8.12 x 6.35 x 4.82 cm)
WEIGHT (INCLUDING BATTERY & BRACKET): 3.7 OZ. (104.9 g)
COLOR: WHITE
OPERATING TEMPERATURE: 32° TO 103° F (0° TO 39° C)
RELATIVE HUMIDITY: 5-95% NON-CONDENSING
BATTERY (INCLUDED, NOT INSTALLED): ONE (1) PANASONIC CR123A,
OR EQUIVALENT LITHIUM BATTERY
INCLUDED ACCESSORIES: MOUNTING BRACKETS AND SCREWS, PLASTIC
WALL ANCHORS
WARRANTY: FOR THE LIFE OF THE INSTALLATION
• KEEP BATTERY AWAY FROM SMALL CHILDREN. IF BATTERY IS SWALLOWED,
PROMPTLY SEE A DOCTOR.