User's Manual

MOUNTING
1. Optimal mounting height is 7.5 Ft. Attach the MotionControl to the [A] mounting arm with a screw.
Screw the [B] mounting bracket into the wall using the 2 wall mount screws. Place the
MotionControl on the mounting bracket and screw in the top screw. To tilt the
MotionControl simple loosen the screw, adjust the unit ( 1 or 2 clicks) and re-tighten.
FAQ’s and HINTS
Question Answer
My MotionControl unit does not turn the lights on. Make sure the unit is properly learned into the respective Zone Control
Receiver. Make sure that there are not any large metal objects or steel
Reinforced concrete walls between the MotionControl and the Zone
Control.
My MotionControl unit senses all movement in the Make sure the unit is properly mounted. Tilting the MotionControl down
area including my pets. will pick up more movement including animals.
What can cause objects to trigger the MotionControl? Positioning the MotionControl into direct sun light.
Close proximity to a heating or cooling A/C duct.
Vegetation that moves in front of a heated source.
How should I mount the MotionControl to get the most Mount the MotionControl 7.5’ high facing the area
effective use of it? to be protected and make sure that there are no obstacles
such as walls, furniture, posts, counter etc. that are interfering with the
beam pattern. Also check to make sure that there is no source of heat or
cold to interfere with the MotionControl function.
If I have a long wall and need to install multiple Mounting them between 3 and 4 meters (10’ and 13’) apart
MotionControl units then how far apart should I mount them? insures that you get good beam coverage of the area.
How many MotionControl units can I learn into a Zone Control? Each MotionControl unit acts like a transmitter. Each ZoneControl can
Learn 8 separate transmitters.
Why won’t my MotionControl shut off after 5 minutes? Did you change the duration from 5 to 10-60 minutes? If the
MotionControl senses movement after 4 minutes it will stay on for
another 5 minutes. If the duration has been changed to a longer time
the MotionControl will stay on for that additional timeframe.
Specifications
Power source use CR123A 3V, Panasonic lithium battery only
Dimensions (L x W x H) 3.5” x 3.5” x 3.5”
Weight 5.5 oz. (with battery and bracket)
Typical battery life 5 to 8 years
Operating temperature 32 to 120°F (0 to 49°C)
Operating frequency 433 MHz
Maximum horizontal sensing angle 110°
Maximum detection range 40’
Technical support
Toll-free: [phone] in the US, including Alaska and Hawaii; Puerto Rico; Canada.
Outside the toll-free area: Contact your local dealer.
FCC compliance
This device complies with part 15 of the FCC rules. Operation is subject to the following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.