User's Manual

Distance Ft.
0
1
2
3
4
5
6
7
8
0 5 10 15 20 25 30 35 40 45
Distance (feet)
Height
-0 degrees
To transmit the data to the ZoneControl make sure you swipe reed #1
TRANSMIT
STEPS
1. Swipe reed # 1. ZoneControl will start to click.
2. Within about 2 ft away, set the wireless programmer to "Send time/date" and hit OK.
4.
Press or
to change to Day &
Night
5.
Press key to
confirm
DURATION
STEPS
Night/Day
STEPS
1. Scroll down to the 2. Press key 3. Press to move
down to the Night
only line
You can change the Setting from Night Only to Day & Night if
desired.
Follow the steps below to change the Motion Sensor time duration
Do not release the OK button until you hear the loud beep.
Time can be changed to 10, 15, 20, 25, 30 , 45 or 60 minutes.
4. Press key to
confirm
You can now send the Motion Sensor Time and Day/Night Data
1. Scroll down to the 2. Press key 3. Press or
to change the time
duration
SENSOR COVERAGE PATTERNS
The Charts demonstrate how the beam pattern changes as you tilt the angle of the MotionControl.
All units are in feet. 0° is the MotionControl facing straight outwards with no tilt(fig1). -9° is the MotionControl tilted down one click(fig 4).
-18° is the MotionControl tilted down 2 clicks(fig 2). +9° is the MotionControl tilted up one click(fig 3).
CHANGING THE DURATION OF THE MOTIONCONTROL
To change the duration on the MotionControl, utilize the programmer. (v2.0 or later). The MotionControl comes with a 5 minute setting
on the sensor duration. Utilize the following instructions to change the desired duration.
Distance Ft.
0
1
2
3
4
5
6
7
8
0 5 10 15 20 25 30 35 40 45
Distance (feet)
Height
-9 degrees
Distance Ft.
0
1
2
3
4
5
6
7
8
0 5 10 15 20 25 30 35 40 45
Distance (feet)
Height
+ 9 degrees
Distance Ft.
0
1
2
3
4
5
6
7
8
0 5 10 15 20 25 30 35 40 45
Distance (feet)
Height
-18 degrees