User's Manual

Verifying the programming and RF communications
(Per customer requirements)
Case Tamper Detection
Removing the cover of the SW-xxx-V2 will cause the integral transmitter to send
a case tamper report to the receiver. This tamper condition will remain on the
system until the case cover is reinstalled and the integral transmitter sends a
tamper restore to the receiver.
General Specifications
Operating Temperature: 32° to 120° F (0° to 49° C)
Operating Rel. Humidity: 5 to 95%, non-condensing
Operating Frequency: 433.92 MHz
Battery Type: 3-Volt CR2032 Lithium Battery
IMPORTANT INFORMATION ABOUT RADIO DEVICES
1. This device provides a reliable communications link and fills an important need in
portable wireless signaling. However, there are some limitations which must be
observed.
2. For US installations only: the radios are required to comply with FCC rules and
regulations including FCC part 15 devices. As such, they have limited transmitter
power and therefore limited range.
3. A receiver cannot respond to more than one transmitted signal at a time and may
be blocked by radio signals that occur on or near their operating frequencies
regardless of code settings.
4. Changes or modifications to the device may void FCC compliance
5. Infrequently used radio links should be tested regularly to protect against
undetected interference or fault.
6. RF signals can be affected by metal objects including metal doors or large mirrors.
Care should be taken to avoid these objects during installation as they can interfere
with proper operation.
FCC compliance statement
This device complies with FCC Rules and Regulations as Part 15
devices as well as Industry Canada Rules and Regulations. Operation is subject to the
following two conditions: