User's Manual

(Per AT&T requirements)
Verifying the programming and RF communications
(Per AT&T requirements)
Case Tamper Detection
Removing the cover of the SW-ATT-TF will cause the integral transmitter to
send a case tamper report to the Digital Life Controller. This tamper condition
will remain on the system until the case cover is reinstalled and the integral
transmitter sends a tamper restore to the Digital Life Controller.
IMPORTANT INFORMATION ABOUT RADIO DEVICES
1. AT&T radio controls provide a reliable communications link and fill an important
need in portable wireless signaling. However, there are some limitations which
must be observed.
2. For US installations only: the radios are required to comply with FCC rules and
regulations including FCC part 15 devices. As such, they have limited transmitter
power and therefore limited range.
3. A receiver cannot respond to more than one transmitted signal at a time and may
be blocked by radio signals that occur on or near their operating frequencies
regardless of code settings.
4. Changes or modifications to the device may void FCC compliance
5. Infrequently used radio links should be tested regularly to protect against
undetected interference or fault.
6. RF signals can be affected by metal objects including metal doors or large
mirrors. Care should be taken to avoid these objects during installation as they
can interfere with proper operation.
FCC compliance statement
This device complies with FCC Rules and Regulations as Part 15 devices as well as
Industry Canada Rules and Regulations. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that
may cause undesired operation.
Conformité Réglementaire
Ce dispositif est conforme à la réglementation de la IC et (Partie 15) de la
FCC. Son fonctionnement est soumis à deux conditions : (1) ce dispositif