User's Manual

2. Transmitters shall be learned by the repeater by manual actuation of
the actual transmitter (fault & restore in 2 Sec. (See list in basic
specifications.)
a. Once a transmitter is learned the integral LED indicator shall
blink one (1) time verifying that the transmitter has been learned
by the repeater.
b. The repeater shall automatically exit the “Learn Mode.”
3. To learn additions transmitters, repeat Steps 1 and 2.
Determining the number of transmitters learned into the memory
1. Push and hold the “Learn Button.”
2. Continue to hold the “Learn Button.”
3. After approximately five (5) seconds the LED shall count out the
number of transmitters learned by the repeater by blinking one (1) time
for every transmitter leaned by the repeater.
a. Eight (8) blinks indicates that eight (8) transmitters have been
learned by the repeater
Erasing Transmitters from the memory
1. Push and hold the “Learn Button.”
2. Continue to hold the “Learn Button.”
3. After approximately five (5) seconds the LED shall count out the
number of transmitters learned by the repeater by blinking one (1) time
for every transmitter leaned by the repeater.
4. Approximately five (5) seconds after counting the number of
transmitters learned by the repeater, the LED will blink indicating that
the memory has been erased
Basic Specifications
Physical
Overall Size: 5.0 inch x 2.6 inches x 1.3 inches
Material: High impact ABS Plastic
Color: AT&T White
Power
Nominal Input Voltage: 120VAC, 50/60 HZ
Nominal Current: Less than 100 milliamperes