SDS
Safety Data Sheet
LUPRANATEM20 ISO
Revision date : 2015/10/05
Page: 6/15
Version: 5.2
(30089687/SDS_GEN_US/EN)
Further information on storage conditions: Formation of CO2 and build up of pressure possible. Keep
container tightly closed and in a well-ventilated place. Outage of containers should be filled with dry
inert gas at atmospheric pressure to avoid reaction with moisture.
Storage stability:
Storage temperature: 32 - 110 °F
Protect against moisture.
8. Exposure Controls/Personal Protection
Components with occupational exposure limits
Diphenylmethane-4,4'-
diisocyanate (MDI)
OSHA PEL
CLV 0.02 ppm 0.2 mg/m3 ; CLV 0.02 ppm 0.2
mg/m3 ;
ACGIH TLV
TWA value 0.005 ppm ;
P-MDI
OSHA PEL
CLV 0.02 ppm 0.2 mg/m3 ; CLV 0.02 ppm 0.2
mg/m3 ;
ACGIH TLV
TWA value 0.005 ppm ;
Isocyanic acid,
polymethylenepolyphenylen
e ester (P-MDI)
OSHA PEL
CLV 0.02 ppm 0.2 mg/m3 ; CLV 0.02 ppm 0.2
mg/m3 ;
ACGIH TLV
TWA value 0.005 ppm ;
Advice on system design:
Provide local exhaust ventilation to maintain recommended P.E.L.
Personal protective equipment
Respiratory protection:
When workers are facing concentrations above the occupational exposure limits they must use
appropriate certified respirators. When atmospheric levels may exceed the occupational exposure
limit (PEL or TLV) NIOSH-certified air-purifying respirators equipped with an organic vapor sorbent
and particulate filter can be used as long as appropriate precautions and change out schedules are
in place. For emergency or non-routine, high exposure situations, including confined space entry,
use a NIOSH-certified full facepiece pressure demand self-contained breathing apparatus (SCBA) or
a full facepiece pressure demand supplied-air respirator (SAR) with escape provisions.
Hand protection:
Chemical resistant protective gloves should be worn to prevent all skin contact., Suitable materials
may include, chloroprene rubber (Neoprene), nitrile rubber (Buna N), chlorinated polyethylene,
polyvinylchloride (Pylox), butyl rubber, depending upon conditions of use.
Eye protection:
Tightly fitting safety goggles (chemical goggles). Wear face shield if splashing hazard exists.
Body protection:
Cover as much of the exposed skin as possible to prevent all skin contact., Suitable materials may
include, saran-coated material, depending upon conditions of use.
General safety and hygiene measures:
Wear protective clothing as necessary to prevent contact. Eye wash fountains and safety showers
must be easily accessible. Observe the appropriate PEL or TLV value. Wash soiled clothing
immediately. Contaminated equipment or clothing should be cleaned after each use or disposed of.