System information

Monitoring
93
ProSAFE Single Band 802.11n Wireless Access Point WN203
Country / Region The country or region for which the wireless access point is licensed for use. For
information about how to change the country or region, see Configure Basic General
System Settings and Time Settings on page 20.
Note: It might not be legal to operate this wireless access point in a country or region
other than one of those identified in this field.
Firmware Version The version of the firmware that is installed.
Serial Number The serial number of the wireless access point.
Current Time The current time. For information about how to change the time settings, see
Configure Basic General System Settings and Time Settings on page 20.
Current IP Settings
For information about how to change any of these IP settings, see Configure the IP Settings on page 22.
IP Address The IP address of the wireless access point.
Subnet Mask The subnet mask for the address of the wireless access point.
Default Gateway The default IP gateway for the wireless access point communication.
DHCP Client Enabled indicates that the current IP address was obtained from a DHCP server on
your LAN network. Disabled indicates a static IP configuration.
Current Wireless Settings for 802.11b, 802.1
1g, or 802.11ng
Note: The section heading depends on the configured wireless mode.
Access Point Mode The operating mode of the wireless access point. One of the following modes is
indicated:
• Access Point
• Point-to-Point Bridge
• Point-to-Point Bridge with Access Point
• Multi-Point Bridge with/without client association
For information about how to change the mode, see Configure Wireless Bridging on
page 75.
Channel / Frequency The channel that the wireless port is using. For information about how to change the
channel and frequency
, see Configure 802.1
1b/bg/ng Wireless Settings on page 25.
Rogue AP Detection
Enabled indicates that rogue AP detection is enabled. Disabled indicates that it is not.
Setting Description