System information

Introduction
13
ProSAFE Single Band 802.11n Wireless Access Point WN203
4. Power socket for a 12 VDC, 1A power adapter.
5. Reverse SMA connector for an optional 2.4 GHz antenna.
If you have purchased external antennas, see Configure Advanced Wireless Settings on
page 70 for information about how to enable the external antennas.
Bottom Panel with Product Label and Reset to Factory
Defaults Button
The product label on the bottom of the wireless access point’s enclosure displays factory
default settings, regulatory compliance, and other information. The bottom panel also
contains the recessed Reset to Factory Defaults button, which is indicated on the product
label.
user name: admin
password: password
http://192.168.0.100
272-11850-02
Made in China
Designed by NETGEAR in California
Single Band 802.11n Wireless Access Point
WN203
Reset to
Factory Defaults
12V 1.0A
Power
2.4 Ghz2.4 Ghz Console LAN
MAC
SERIAL
This device complies with part 15 of the FCC Rules and Canada ICES-003.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
FCC ID: PY312400222
IC: 4054A-12400221
ProSAFE
Reset to Factory Defaults button
Figure 3. Product label on the bottom
 To reset the wireless access point to factory default settings:
Use a sharp object to press and hold the Reset to Factory Defaults button for about
10 seconds.
All custom configuration settings are lost, and the default password is restored. For more
information, see Restore the Wireless Access Point to the Factory Default Settings on
page 58.