Technical data

3
A B C D E F G
1
735 790 264 280 510 368 400
2
830 790 264 280 510 585 620
3
830 982 364 350 632 585 620
Wall Mount Units
Dimensions
1 SP101HW – 201HW – 301HW – 101LW 2 SP401HW – 501HW – 201LW 3 SP601HW – 301LW
Location.
To obtain the optimum operation of the unit the following is recommended:
A) Place the unit in a room away from any heat source.
B) Limit the number of door openings
C) Make sure the unit has adequate ventilation
D) Fit a drain pipe to the Condensate drain line Ø 14 from the vaporisation vessel at the bottom of the unit where
required
Note: The units are fitted with two additional self regulating heaters in the vaporisation tray but under extreme
circumstances it may be necessary to fit the drain pipe avoiding water spillage over the floor.
Installation.
1 SP101HW – 201HW – 301HW – 101LW 2 SP401HW – 501HW – 201LW 3 SP601HW – 301LW
*NOTE: Dimension for 75mm insulation increase by 24mm if 100mm insulation is used.
On low temperature models a drain line heater is inserted into the drain fitting.
A
mm
B*
mm
C
mm
D*
mm
E
mm
F
Mm
1 19 316 288 83 43 6
2 19 316 503 83 43 6
3
19
425
503
83
43
6
Drain
Fitting