Installation guide

Remote Connection to the SignalPath Device 1-19
SP201-SA™ Customization and Maintenance Guide
Note: Some products include a webserver so that clients can use a browser
for remote management. The same process is used to establish the
connection: The host must set up a client account, etc.
1.6.3 Sample Connection
This guide uses the commercial product pcAnywhere to illustrate
configuration of a remote connection. In pcAnywhere, the PC connected to
the SignalPath device is a host. The host and the client are configured in
similar ways in pcAnywhere. Before configuring, determine the information
(IP address, etc.) for each side of the connection.
Note: One licensed copy of pcAnywhere must be on each PC. Other
products may use a different distribution of software. See the
manufacturer’s requirements for licensed use of a software package.
Configure the host in the following way:
• In Windows, enable remote access.
• Open pcAnywhere and select the menu button Be a Host PC.
• In the pcAnywhere window, select the icon for Add a Host PC Item.
• When prompted, enter the host’s name for the connection.
• When prompted, select TCP/IP connection.
• In the subsequent prompt window, uncheck Automatically launch
session upon wizard completion.
• After the connection setup has finished, right-click the icon for the
connection. (The icon shows the connection name.) Then select
Properties.
• Select the Callers tab. Then check Specify individual caller privileges,
select the Add Caller icon, and enter the client information, including
password.