Installation guide

Connecting to the Control Console 1-13
SP201-SA™ Customization and Maintenance Guide
7 At the local terminal, use the local modem to dial the remote
modem’s number. When the remote modem answers, configure or
manage the remote SignalPath device.
1.5.2.1 Sample Settings for an External Modem
This section provides settings for one type of external modem, the U.S.
Robotics Sportster®. Also see Section 1.5.2.2, Sample Command Sequence for an
External Modem.
Table 1-3. DIP Switch Settings for U.S. Robotics Sportster® External Modem
Switch Setting Definition
1 down Data terminal ready override
2 up Verbal result codes
3 up Suppress result codes
4 down No echo, offline commands
5 up Auto answer on first ring (or higher, if
specified in NVRAM)
6 up Carrier detect normal
7 up Load configuration profile from NVRAM
8 down Smart mode
Table 1-4. Sample Profile Setup Commands for U.S. Robotics Sportster®
External Modem
Command Description
at command prefix for modem’s attention—e.g., ATH
y0 user profile 0 setting in NVRAM
&w0 writes (saves) current setting to profile 0 in NVRAM
i4 displays current settings
i5 display profiles in NVRAM
dt dial, using dual tone (touch tone)
+++ switch to modem command mode
h hang up modem