Use and Care Guide

4
598-1162-04
Maximum
Maximum Range Coverage Angle
MAX
MIN
RANGE
ON-TIME
DUAL BRITE™
TEST 1 5 20
MINUTES
OFF
3
6
DUSK TO
DAWN HOUR
B
O
O
S
T
Motion
Motion
8ft.
(2.4m)
 70ft. 100ft.
 (21m) (30.5m)
Boosted
Sensor
240°
DualZone™
DualZone™
DualZone™
DualZone™
Bottom of Sensor
Avoid aiming the control at:
•Objects that change temperature rapidly, such as
heating vents and air conditioners. These heat
sourcescouldcausefalsetriggering.
•Areaswherepets or trafficmaytriggerthecontrol.
•Nearby large, light-colored objects reflecting light
maytriggertheshut-offfeature.Donotpointother
lights at the sensor.
Least Sensitive Most Sensitive
NOTE: DualZone™isanewzoneofdetectionwhich
was added as an option to select Heath
®
/Zenithmotion
sensingproducts.Thisfeatureaddsazoneofdetec-
tionunderthemotionsensor.DualZone™requires
noadditionaladjustmentandoperatesinconjuction
withtheforward-lookingsensor.
3. Loosentheclampscrewinthe
sensor ball joint and gently
rotate the sensor.
4. Walk through the coverage
area noting where you are
whenthelightsturnon(also,
theLEDwillashseveraltimes
whenmotionisdetected).Move
thesensorheadup,down,or
sidewaystochangethecover-
age area. Keep the sensor at
least 2" (51 mm) away from
the bulbs.
5. AdjusttheRANGEasneeded.
RANGE set too high may
increasefalsetriggering.
❒ Secure the sensor head by
tightening the clamp screw.
Donotovertightenthescrew.
6. SettheamountofTIMEyouwantthelightstostay
onaftermotionisdetected(1,5,or20minutes).
7. Set the DualBrite
®
switchtotheamountoftime
afterduskyouwantthelightsonatlowlevel(Off,
3,6Hrs.,Dusk-to-Dawn).
Clamp
Screw
Ball
Joint
Aim Sensor
Down for Short
Coverage
Aim Sensor
Higher for Long
Coverage
TEST AND ADJUSTMENT
1. Turn on the circuit breaker and light switch.
NOTE: Sensor has a 1
1
/
2
 minute warm up period
beforeitwilldetectmotion.Whenrstturned
on,wait1
1
/
2
minutes.
2. TurntheRANGEcontroltotheminimumposition
(MIN),DualBrite
®
toOFF,andtheON-TIMEcontrol
totheTESTposition.
NOTE: Ifxtureismountedhigherthan8ft.(2.4m),aiming
thesensordownwillreducecoveragedistance.
Thedetectorislesssensitivetomotiondirectlytowardsit.
WARNING - Risk of fire. Do not aim the bulbs
at a combustible surface within 3 ft. (1 m).