Use & Care Guide

5
598-1343-01
TROUBLESHOOTING GUIDE
SYMPTOM POSSIBLE CAUSE SOLUTION
Lightwillnotcomeon. 1. Lightswitchisturnedoff.
2. Lampislooseorburnedout.
3. Fuseisblownorcircuitbreakeristurnedoff.
4. Daylightturn-offisineffect.
5. Incorrectcircuitwiring,ifthisisanewinstallation.
6. Lightcontrolaimedinwrongdirection.
1. Turnlightswitchon.
2. Checklampandreplaceifburnedout.
3. Replacefuseorturncircuitbreakeron.
4. Recheckafterdark.
5. Verifywiringiscorrect.
6. Re-aimlightcontroltocoverdesiredarea.
Lightcomesoninday-
light.
1. Light control may be installed in a relativelydark
location.
2. LightcontrolisinTEST.
1. Thextureisoperatingnormallyunderthesecondi-
tions.
2. Setcontrolswitchto1,5,or10minutes.
Light comes on for no
apparentreason.
1. Lightcontrolmaybesensingsmallanimalsorauto-
mobiletrafc.
2. Rangeissettoohigh.
1. Re-aimlightcontrol.
2. Reducerange.
Lightstaysoncontinu-
ously.
1. Alampispositionedtooclosetothelightcontrolor
pointedatnearbyobjectsthatcauseheattotrigger
thelightcontrol.
2. Thelightcontrolmaybepickingupaheatsource
likeanairvent,dryervent,orbrightlypainted,heat-
reectivesurface.
3. Lightcontrolisinmanualmode.
1. Repositionthelampawayfromthelightcontrolor
nearbyobjects.
2. Re-aimlightcontrol.Reducerange.
3. SwitchlightcontroltoAUTO.
Light flashes on and
off.
1. Heatorlightfromthelampsmaybeturningthelight
controlonandoff.
2. Heatbeingreectedfromotherobjectsmaybeturn-
ingthelightcontrolonandoff.
3. LightcontrolisintheTESTmodeandwarmingup.
1. Repositionthelampawayfromthelightcontrol.
2. Repositionlightcontrol.
3. Flashingisnormalundertheseconditions.
Lightashesonce,then
stays off in manual
mode.
Lightcontrolisdetectingitsownlights. Repositionlamptokeepareabelowthelightcontrol
relativelydark.