Use and Care Guide

2
204081-01
INSTALLATION
Foreavemountonly:
1.Swingthesensorheadtowardstheclampscrew
joint.
If thesensor pops outof the balljoint, loosen the
clampscrewandpushthesensorbackintotheball
joint.Tightentheclampscrewwhendone.
2.Thenrotatethesensorheadclockwise180°sothe
controlsfacedown.
DualBrite
®
Timer
Lightcomesonhalfbrightforselectedtimeafterdusk
(Off,3hr.,6hr.,untildawn).SelectingOFFdisables
thisfeature.Themotionsensingfeatureswillcontinue
toworkasdescribedinthismanual.Ifmotionissensed,
thelightturnsonfullbrightfortheON-TIME(1,5,or
20minutes)thenreturnstodimmode.
Move ON-TIME Switch to
1, 5, or 20 minutes
Mode Switching Summary
Flip light switch off
for one second then
back on*
MANUAL MODE
AUTO
TEST
* Ifyougetconfusedwhileswitchingmodes,turnthe
poweroffforoneminute,thenbackon.Afterthecali-
brationtimethecontrolwillbeintheAUTOmode.
Controls
ClampScrew
Controls
Controls
Foreasyinstallation,selectanexistinglightoperated
byawallswitchforreplacement.IMPORTANT:Do
NOTusewithdimmersortimers.
Forbestperformance,mountthextureabout8feet
(2.4m)abovetheground.NOTE:Ifxtureismounted
higherthan8feet(2.4m),aimingthesensordownwill
reducecoveragedistance.
Before installing the light fixture under an eave, the
sensor head must be rotatedasshowninthenext
twostepsforproperoperationandtoavoidtheriskof
electricalshock.
NOTE: Lightxtureandsensorshouldbemountedas
shownabovewheninstalled(dependingupontypeof
installation).
Wall Mount Eave Mount