Installation Guide
8
200478-03
CARE AND MAINTENANCE
• To prolong the original appearance, clean with clear water
and a soft damp cloth only.
• Do not use paints, solvents, or other chemicals on this
light xture. ey could cause a premature deterioration
of the nish. is is not a defect in the nish and will not
be covered by the warranty.
• Do not spray with hose or power washer.
BULB REPLACEMENT
1. While holding the light xture cover with one hand,
remove the two decorative nuts holding the cover onto
the base.
2. Replace bulb(s) (tungsten incandescent, candelabra
base, type “B”, 25 watt maximum).
3. Replace light xture cover onto xture base.
4. Secure with decorative nuts.
Remove Light Fixture Cover
DUAL BRITE
®
ON-
TIME
TEST 1 5 10 MIN
OFF 3 6
DUSK
TO DAWN
3. Remove paper backing from one side of cut foam tape
and adhere foam tape to inside of lens shield.
4. Remove paper backing from other side of cut foam tape
and adhere lens shield to sensor lens.
5. Retest to conrm that the sensor is no longer false
triggering.
Note: To help determine amount of lens shield required,
apply small sections one at a time. Additional sections can
be applied if necessary.
Lens Shield
Sensor Lens
DUAL BRITE
®
ON-TIME
TEST 1 5
1
0 MIN
OFF 3 6
DUSK
TO DAWN
Decorative Nut
Light Fixture Base
Light Fixture Cover