Use and Care Guide

6
200478-02
DUAL BRITE
®
ON-
TIME
TEST 1 5 10 MIN
OFF 3 6
DUSK
TO DAWN
Least Sensitive Most Sensitive
The sensor is less sensitive to motion directly
towardsitandmore sensitive tomotionacross
coverage area.
Sensor
Motion
Motion
ADJUSTMENT OF COVERAGE
AREA
Thesensoronthislight xturedetects“motion”
by the movement of heat (body heat) across the
coveragearea.However,followingareexamples
of objects that also produce heat and can cause
the sensor to false trigger:
•PoolsofWater •AirConditioners
•DryerVents •Fenced-InAnimals
•HeatingVents •AutomobileTrafc
Ifyoususpectthataheatsourceofthistypeisfalsely
triggering the sensor and reducing the sensitivity
does not solve the problem, then a lens shield
(included) can be installed. The plastic lens shield
isdividedinto6sections.Eachsectionwillreducethe
coverageangleby30degrees.Also,thetipofeach
section may be removed to change the effective
range of the sensor.
1. Break off the amount of lens shield needed to
block the desired area of coverage.
2. Cutdesiredamountoffoamtapeneededto
adhere the lens shield to the sensor lens.
3. Removepaperbackingfromonesideofcut
foam tape and adhere foam tape to inside of
lens shield.
4. Removepaperbackingfromothersideofcutfoam
tape and adhere lens shield to sensor lens.
5. Retesttoconrmthatthesensorisnolonger
false triggering.
Note: To help determine amount of lens shield
required,applysmallsectionsoneatatime.Ad-
ditional sections can be applied if necessary.
LensShield
Sensor
Lens
Area
Blocked
Area
Blocked
Lens
Shield
Lens
Shield
Portion
Removed
Effective
CoverageArea
(TopView)