Use and Care Guide

5
200478-02
TESTING
1. Turn on the circuit breaker and light switch.
Note: Sensor has a 1
1
/
2
minutewarmupperiod
beforeitwilldetectmotion.Whenrstturnedon
wait1
1
/
2
minutes.
2. SettheON-TIMEswitchtotheTESTposition
and the DualBrite
®
switchtotheOFFposition.
3. Walkthroughthecoverageareanotingwhere
youarewhenthelightsturnon.InTESTmode,
lightwillstayonforonly5secondsthenturn
off.
4. AdjusttheSENSITIVITYtoincreaseordecrease
the range as needed. Too much sensitivity may
cause false triggering due to heat sources in the
coverage area (see Adjustment of Coverage
Area or Troubleshooting section).
Itisalsopossibletowiretwomotionsensinglightsso
thateitherxturewillturnonbothlightsatthesame
time(dualmastersystem).Itisrecommendedthatonly
peoplewithelectricalwiringexperienceattemptthis
conguration.Pleasecallourcustomerservicenumber
(1-800-858-8501 - English Speaking Only) before
attemptingthiswiring.If the dual controlled wiring
is not done correctly, it can destroy both motion
sensing fixtures and void your warranty.
INSTALL FIXTURE BASE TO
JUNCTION BOX
1. Pushwiresintothejunctionbox.
2. Slide light xturebaseonto xturescrewsand
tighten decorative nuts snugly against the base.
3. Install four candelabra base light bulbs (25
Watts maximum each).
4. Refer to TESTING section before installing
cover.
5. Afterswitchesaresetandtestingiscomplete,
usethe2decorativenutstoinstallthecover.
DUAL BRITE
®
ON-TIME
TEST 1
5 10 MIN
OFF 3 6
DUSK
TO DAWN
DualBrite
®
ON-TIME
DUSK
OFF
3
HR 6HR TO DAWN
TEST 1 5 10 MIN
Sensor
Lens
5. SettheamountofON-TIMEyouwantthelight
to stay on after motion is detected (1, 5, or 10
minutes).
6. Settheamountoftimeyouwantthelightto
stayonintheAccentmode(Off,3hours,6
hours,ordusk-to-dawn).
SENSITIVITY
+
DUAL BRITE
®
ON-TIME
TEST 1
5 10 MIN
OFF 3 6
DUSK
TO DAWN
FixtureScrew
Junction Box
DecorativeNut
25WattCandelabra
Base Bulb
Maximum Range C o v e r a g e
Angle* (Top View)
360°
30Feet(9.1m)
in all Directions
*Withoutlensshieldinstalled.
8ft.(2.4m)