Use and Care Guide

4
200478-02
One Motion Sensing Light
Two Motion Sensing Lights (Working Independently)
Other Wiring Options
Thisxturecanbewiredtocontrolanotherstandard
ormotionsensinglightxture(s).Seethefollowing
wiringdiagramsforproperconnections.
Note:Allwiringshouldberuninaccordancewith
the National Electrical Code through conduit or
another acceptable means. Contact a qualified
electrician if there is any question as to the
suitability of the system.
Whencontrollinganadditionallightxture(s),the
maximumwattage of themotionsensor on this
xtureshouldbeobserved.Seeillustrationbelow
foranexampleofamaximumlampwattageload
calculation.
Black to Black
White to White
Ground
to Ground
Black to Black
White to White
Ground to Ground
Wiring Motion Sensing Light to Control Standard
Fixture
Ground to
Ground
StandardLightFixtureMotionSensingLight
Black to Black
White to White
Red to Black
Maximum Load for
Motion Sensor –
200 Watts
Maximum Lamp
Wattage Rating
for Light Fixture –
100 Watts
Maximum Lamp
Wattage Rating
for Light Fixture –
100 Watts
TOTAL Load for
Motion Sensor –
200 Watts
CONTROLLING Fixture
CONTROLLED Fixture 1
IMPORTANT: When determining the maximum
lampwattageratingofthexturetobecontrolled,
refertothemaximumlampwattagelabelonthe
xtureandnotthewattageratingonthelamp(s)
currentlyinstalledinthexture.
Wiring Motion Sensing Light to Control Another
Motion Sensing Light
Black to Black
White to White
Ground to Ground
Black to Red
and Black
Red to Black
Controlled Motion
SensingLight
MotionSensingLight