Installation Guide

7
207738-01
Note: When rst turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
* resets to Auto Mode at dawn.
Mode: On-Time Works: Day Night
Test
5 Seconds x x
Auto
1, 5, or 10 Minutes x
Accent
3, 6 Hour, To Dawn x
Manual
To Dawn* x
Operating Modes
• Motion Sensor (AUTO) – is light xture is designed
to automatically turn on when the sensor detects a tem-
perature dierence moving across the front of the motion
sensor. e light will turn o automatically after a set
amount of time. e ON-TIME control should be set
to 1, 5, or 10 minute setting and the wall switch should
be left in the ON position at all times.
• Manual Mode – is light can be activated to stay on full
bright after dusk (sunset) for only one night at a time. It
automatically resets to motion sensing at dawn (sunrise).
Manual mode must be re-activated each night. Note: If
power to the light xture is o for more than 5 seconds,
allow the electronic circuitry in the sensor to calibrate
(90 seconds) prior to switching to manual mode.
1. To turn on MANUAL mode, switch the light o at
the wall switch for 1 to 2 seconds and then back on.
2. To return to AUTO mode, switch the light o at the
wall switch for 1 to 2 seconds and then back on.
Note: e sensor will also reset to AUTO mode at
sunrise.
Turn Switch OFF for
1 to 2 seconds
Turn Switch
Back ON
CARE AND MAINTENANCE
• To prolong the original appearance, clean with clear water
and a soft damp cloth only.
• Do not use paints, solvents, or other chemicals on this
light xture. ey could cause a premature deterioration
of the nish. is is not a defect in the nish and will not
be covered by the warranty.
• Do not spray with hose or power washer.
BULB REPLACEMENT
1. Remove the two decorative screws and remove the
decorative cage.
2. Twist the globe counter-clockwise and remove the
globe.
3. Replace bulb (tungsten incandescent, medium base,
type “A-15”, 60 watt maximum).
4. Replace globe and twist clockwise to secure.
5. Align the decorative cage with the threaded holes and
secure with decorative screws.
Decorative Screw
Remove Globe Assembly
Decorative Cage
Globe