Installation Guide
7207737-03
Note: When rst turned on wait about 1
1
/
2
minutes for
the circuitry to calibrate.
* resets to Auto Mode at dawn.
Caulking Around Fixture Base
Mode: On-Time Works: Day Night
Test
5 Seconds x x
Auto
1, 5, or 10 Minutes x
Manual
To Dawn* x
Final Setup
1.
Adjust the sensitivity (SENS) to increase or decrease
the range as needed. Too much sensitivity may cause
false triggering due to heat sources in the coverage area
(see
Testing and Adjustments or Troubleshooting
section).
2. Set the amount of ON-TIME you want the light to
stay on after motion is detected (1, 5, or 10 minutes).
3. Caulk around xture base with silicone weather seal-
ant after all Testing and Adjustments are complete.
Operating Modes
• Motion Sensor (AUTO) – is light xture is designed
to automatically turn on when the sensor detects a tem-
perature dierence moving across the front of the motion
sensor. e light will turn o automatically after a set
amount of time. e ON-TIME control should be set
to 1, 5, or 10 minute setting and the wall switch should
be left in the ON position at all times.
• Manual Mode – is light can be activated to stay on full
bright after dusk (sunset) for only one night at a time. It
automatically resets to motion sensing at dawn (sunrise).
Manual mode must be re-activated each night. Note: If
power to the light xture is o for more than 5 seconds,
allow the electronic circuitry in the sensor to calibrate
(90 seconds) prior to switching to manual mode.
1. To turn on MANUAL mode, switch the light o at
the wall switch for 1 to 2 seconds and then back on.
2. To return to AUTO mode, switch the light o at the
wall switch for 1 to 2 seconds and then back on.
Note: e sensor will also reset to AUTO mode at
sunrise.
Installing Optional Tail Assembly
1.
Remove decorative nut from bottom of motion sensor.
2. read hex nut and rod assembly
onto the threads on the bottom of
the motion sensor. Note: Approxi-
mately half of the hex nut threads
should be threaded onto the motion
sensor threads and half should be on
the threaded rod. Tighten securely.
3. Slide the decorative cover and trim
pieces onto the threaded rod as
shown. Note: e bottom trim piece
has a drain hole.
4. Attach the decorative nut removed
in step one and tighten securely.
Turn Switch OFF for
1 to 2 seconds
Turn Switch
Back ON