Installation Guide

2 207737-03
SAFETY INFORMATION
Please read and understand this entire manual before at-
tempting to assemble, operate, or install the product.
is light xture requires 120-volts AC. All wiring must be
in accordance with the National Electrical Code (Canadian
Electrical Code in Canada). Some local electrical codes
require installation by a qualied electrician.
WARNING
• Turn power o at circuit breaker or fuse when
wiring xture or replacing bulbs. Place tape over
circuit breaker switch and verify power is o at
the xture.
CAUTION
• Do not cut any wires that have factory installed
wire connectors or remove the wire connectors.
is device complies with Part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must
accept any interference received, including interference that
may cause undesired operation.
CAN ICES-3 (B)/NMB-3(B)
PREPARATION
Before beginning installation of product, make sure all parts
are present. Compare parts with hardware contents list. If
any part is missing or damaged, do not attempt to assemble,
install, or operate the product.
Tools Required for Assembly (not included): Phillips and
athead screwdrivers, pliers, wire strippers/cutters, multi-
meter, electrical tape, silicone sealant, safety glasses, work
gloves, and ladder
• For easy installation and to operate the light using Manual
mode, replace an existing light xture operated by a wall
switch.
• Do not connect to dimmers or timers.
• For best performance, mount xture about 6 feet (1.8 m)
above the ground.
Estimated Installation Time: 30 minutes
3x – Wire Connectors
2x – Mounting
Bracket Screw
A - (1x) Mounting Bracket
B - (2x) Fixture Mounting
Screws
C - (2x) Decorative Nut
(This assembly is attached to
the rear of the lantern canopy.)
HARDWARE CONTENTS
Note: Illustrations may vary from actual unit.
A
B
C