User manual

If you selected Custom, enter the custom Test Command that is used to test the

connection, e.g.: myscript 5 10 ping -c 1 -I $if_netdev 15.1.2.3

Note

If the Test Command exits with a return code of zero (0), the test is deemed to have

passed and the connection is considered up. Otherwise, the connection is considered

down. Also note that $if_netdev is replaced with the name of the network interface

on which the test is being run, e.g. ppp0.

If you selected Ping, enter an IP Address to Ping. Ensure you choose a host on the

Internet that can be contacted reliably and responds to pings. You can check whether

you can ping a host under Diagnostics > Network Tests > Ping Test.

Ping Interval is the time to wait between sending each ping. Failed Pings is the

number of missed ping replies before this connection attempt is deemed to have

failed.

Click Finish.

Modify failover levels (primary, secondary, tertiary)

The second and final step of configured Internet failover is associating Internet

connections with and primary, secondary and optionally tertiary connection levels.

Network Setup