User manual

Do not continue until it has reached the line sync state and is ready to connect.

Note

For PPPoE/PPPoA connections, ensure your DSL modem is set to operate in bridged

mode. Typically, for PPPoE connections, your DSL modem must be set to use LLC

multiplexing/encapsulation. For PPPoA connections, your DSL modem must be set to

use VC-based multiplexing/encapsulation.

Select the connection method to use in establishing a connection to your ISP as follows:

PPPoE - If your ISP uses user name and password authentication to access

the Internet.

PPTP - If your ISP has instructed you to make a dial-up VPN connection to the

Internet.

DHCP - If your ISP does not require a user name and password, or your ISP

instructed you to obtain an IP address dynamically.

Manually Assign Settings - If your ISP has given you an IP address or

address range.

If you are unsure, you may let the SnapGear unit attempt to Auto detect ADSL

connection type. Note that the SnapGear unit is unable to detect the PPTP connection

type.

Network Setup