User manual

Select Use the following IP address and enter the following details:

IP address: 192.168.0.100

Subnet mask: 255.255.255.0

Leave the Default gateway and DNS server addresses blank.

Set up the SnapGear unit’s password and network connection settings

Launch your web browser and navigate to 192.168.0.1.

Select Network Setup from the Networking menu.

A login prompt is displayed. Enter the initial user name and password for the SnapGear

unit:

User name: root

Password: default

Note

If you are unable to connect to the management console at 192.168.0.1, or the initial user

name and password are not accepted, press the Reset button on the SnapGear unit’s

rear panel twice, wait 20 – 30 seconds, and try again.

Pressing Reset twice within 2 seconds resets the SnapGear unit to its factory default

settings

Enter and confirm a password for your SnapGear unit. This is the password for the user

root, the main administrative user account on the SnapGear unit. It is therefore

important that you choose a password that is hard to guess, and keep it safe.

Getting Started