User manual

If you selected Manual configuration, some additional information is required.

Otherwise, skip to the next step.

Enter an IP address and Subnet Mask for the SnapGear unit’s LAN connection.

Note

Take note of this IP address and subnet mask, as you will need them later on.

To enable the SnapGear unit’s built-in DHCP server, enter a range of addresses to hand

out in DHCP Server Address Range. PCs and other hosts on your LAN that are set to

automatically obtain network settings are assigned an address from this range, and

instructed to use the SnapGear unit as their gateway to the Internet and as their DNS

server for Internet domain name resolution.

Click Next.

Connect the SnapGear unit to your LAN

Review your configuration changes. Once you are satisfied, click Finish to activate the

new configuration.

Getting Started