User manual

The Quick Setup wizard is displayed.

Changing the Hostname is not typically necessary.

Select how you would like to set up your LAN connection then click Next.

Note

You must select Manual configuration in order to enable the SnapGear unit’s built-in

DHCP server. The SnapGear unit’s DHCP server automatically configures the network

settings of PCs and other hosts on your LAN.

Changes to the SnapGear unit’s LAN configuration do not take effect until the quick setup

wizard has completed.

 (recommended) Select Manual configuration to manually specify the SnapGear

unit’s LAN connection settings.

 Select Skip: LAN already configured if you wish to use the SnapGear unit’s initial

network settings (IP address 192.168.0.1 and subnet mask 255.255.255.0) as a basis

for your LAN settings, and you do not wish to use the SnapGear unit’s built-in DHCP

server. Skip to the next step.

 You may choose to Obtain LAN IP address from a DHCP server on LAN if you

have an existing DHCP server, and wish to rely on it to automatically configure the

SnapGear unit’s LAN connection settings (not recommended). Skip to the next step.

Getting Started