User manual

Enter the following details:



IP address is an IP address that is part of the same subnet range as the SnapGear

unit’s LAN connection (if using the default settings, 192.168.0.2 – 192.168.0.254).



Subnet mask is the subnet mask of the SnapGear unit’s LAN connection (if using the

default settings, 255.255.255.0).



Default gateway is the IP address of the SnapGear unit’s LAN connection (if using

the default settings, 192.168.0.1).



Preferred DNS server is the IP address of the SnapGear unit’s LAN connection (if

using the default settings, 192.168.0.1).

Click OK (or in 95/98/Me, Add then OK, and reboot the PC if prompted to do so).

Perform these steps for each PC on your network.

Quick setup is now complete.

SG Rack Mount Appliance Quick Setup

Unpack the SnapGear unit

Check that the following items are included with your SnapGear unit:



Power cable



SG CD



Network cable

The front panel of the SnapGear unit has two 4-port network switches (A and B), two

network ports (C and D), a serial port, status LEDs, and Erase button.

The rear panel of the SnapGear unit has a power inlet and power switch.

Note

The SG710+ has two gigabit network ports on the rear panel (E and F).

Getting Started