User manual

 If you do not want to use a DHCP server, proceed to Manual configuration of your

LAN.

Automatic configuration of your LAN

If you selected Manual Configuration for the SnapGear unit’s LAN connection, and

supplying DHCP Server Address Range, then the SnapGear unit’s DHCP server is

already set up and running.

Each PC on your LAN must now be set up to automatically obtain network settings.

Click Start > (Settings >) Control Panel and double-click Network Connections (or in

95/98/Me, double-click Network).

If presented with multiple connections, right-click on Local Area Connection (or

appropriate network connection) and select Properties.

Select Internet Protocol (TCP/IP) and click Properties (or in 95/98/Me, TCP/IP > [your

network card name] if there are multiple entries) and click Properties (in 95/98/Me, you

may also have to click the IP Address tab).

Check Obtain an IP address automatically, check Obtain DNS server address

automatically and click OK (in 95/98/Me, reboot the PC if prompted to do so).

Quick setup is now complete.

Getting Started