User manual

Set up the SnapGear unit’s switch

Note

This page will only display if you are setting up the SG560, SG565 or SG580. Otherwise

skip to the next step.

By default, the SnapGear unit’s switch A behaves as a conventional switching hub.

However, it may be configured so that each port behaves as if it were physically separate

from the others.

Select a configuration for the SnapGear unit’s switch, then click Next.

 1 LAN Port, 3 Isolated Ports, select this if you require multiple network segments,

such as a DMZ, guest network or second LAN, or if you want to use multiple

broadband Internet connections for Internet load balancing or Internet failover. Port

A1 is used as the primary LAN connection.

Note

For instructions on setting up multiple network segments and Internet connections,

please refer to the next chapter of this manual.

 4 LAN Ports, select if you don’t want multiple network segments.

Getting Started