User manual

Note

If you wish to retain your existing IP settings for this network connection, click Advanced

and Add the secondary IP address of 192.168.0.100, subnet mask 255.255.255.0.

Set up the SnapGear unit’s password and LAN connection settings

Launch your web browser and navigate to 192.168.0.1.

Select Quick Setup Wizard from the center of the page.

A login prompt is displayed. Enter the initial user name and password for the SnapGear

unit:

User name: root

Password: default

Note

If you are unable to browse to the SnapGear unit at 192.168.0.1, or the initial user name

and password are not accepted, press the black Reset/Erase button on the SnapGear

unit’s rear panel twice, wait 20 – 30 seconds, then try again.

Pressing Reset/Erase twice within 2 seconds resets the SnapGear unit to its factory

default settings.

Enter and confirm a password for your SnapGear unit. This is the password for the user

root, the main administrative user account on the SnapGear unit. It is therefore

important that you choose a password that is hard to guess, and keep it safe.

Note

The new password takes effect immediately. You are prompted to enter it when

completing the next step.

Getting Started