User`s manual

Important Tips
• The working voltage of the camera is 6 V. You can either use 4 or 8 AA batteries, or use
an external 6 V DC power supply (inside + and outside -)
• Please load the batteries according to the indicated polarity on the cover of the battery
cabinet
• Please disable the write-protect on the card before inserting SD card
• The camera has no internal memory for images or videos. Please insert a SD card
before testing the camera. Otherwise, the camera will not save images and videos. If no
SD-card is inserted or the write-protect of the card is not disabled, the camera will shut
down automatically after a long beep
• It is recommended to format the SD-card by the camera when used for the first time
• Do not insert or take out the SD-card when the power switch is at the ON position
• Please set the TV in the AV IN mode when connecting a TV
• The camera will be in the USB mode when connected to a USB port of computer. In
this case the SD card functions as a removable disk no matter the power switch of the
device is ON or OFF
• When the remote control is connected to the camera, turning the power ON will force
the camera into the test mode. Otherwise the camera enters the live mode automatically
• In the test mode, the camera will shut down automatically after 3.5 minutes if no key is
pressed. Please turn on the power again if you want to continue to work with the
remote control
• Please be sure that no power interruption occurs during firmware upgrade. Otherwise
the upgrade process may be interrupted or finished incorrectly. This may cause the
camera to stop functioning properly.