User`s manual

HCO 5-Advanced Setting SG550/SG530
Page 14
This setting is effective only in the Camera mode when the camera is in the Live mode. The
default value is 1 Photo after each trigger.
1 In MENU, press the UP or DOWN key until Capture Number appears, as shown in Fig.
10(a) and 10(1).
2 Press the RIGHT key to change the value to the desired number. The desired number
will be highlighted, as shown in Fig. 10(b) and 10(2).
3 Press the OK key to save or press the MENU key to cancel and exit. After pressing the
OK key, the selected value will no longer be highlighted, as shown in Fig. 10(c) and
10(3).
（a） (1)
（b） (2)
（c） (3)
Figure 10: Setting shooting numbers
4.1.7 Video Length
You can set the video length that the camera will take after each trigger by setting the video
length. This setting is effective only in the Video mode when camera is in the Live mode. The
default value of video length is 10 seconds after each trigger. It can be adjusted from 1 to 60
seconds in the increment of one second. Press the RIGHT key to change the value by one
second or press the RIGHT key and hold for a few seconds, the value will be increased by 5
seconds or 10 seconds.
1. In Menu, Press the UP or DOWN key until Video Length appears, as shown in Fig.
11(a) and 11(1).
2. Press the RIGHT key until the desired value appears, as shown in Fig. 11(b) and
11(2).
3. Press the OK key to save or press the MENU key to cancel and exit. After pressing
the OK key, the selected value will no longer be highlighted, as shown in Fig. 11(c)