User manual

Getting Started
34
Set up your PC to connect to the web management console
Note
The following steps assume you want to set up your SG unit in bridged mode, so that it
sits between your PC and the LAN, transparently filtering network traffic.
If you want to set up your SG unit for NAT mode or to connect directly to your ISP, refer
to the User Manual on the SG CD (\doc\UserManual.pdf).
The SG unit ships with initial network settings of:
IP address: 192.168.0.1
Subnet mask: 255.255.255.0
Next, modify your PC’s network settings to enable it to communicate with the SG unit.
Click Start -> (Settings ->) Control Panel and double click Network Connections.
Right click on Local Area Connection (or appropriate network connection for the newly
installed PCI appliance) and select Properties.
Select Internet Protocol (TCP/IP) and click Properties.
Select Use the following IP address and enter the following details: