Specifications
Required Tools and Parts 45
Chapter 4
Servicing the Device
This chapter describes service and maintenance procedures for SSG 500-series
devices. It includes the following sections:
“Required Tools and Parts” on page 45
“Replacing a PIM” on page 46
“Replacing Power Components (SSG 550 Only)” on page 48
“Upgrading Memory” on page 52
“Replacing the Air Filter” on page 54
Required Tools and Parts
To replace a component on an SSG 500-series device, you need the following tools
and parts:
Electrostatic bag or antistatic mat
Electrostatic discharge (ESD) grounding wrist strap
Flat-tip screwdriver, 1/8-inch
Number-2 phillips screwdriver
NOTE:
For safety warnings and instructions, refer to the Juniper Networks Security
Products Safety Guide. The instructions in the guide warn you about situations that
could cause bodily injury. When working on any equipment, be aware of the
hazards involved with electrical circuitry, and follow standard practices for
preventing accidents.