Specifications

Default Device Settings  33
Configuring the Device
Default Device Settings
Table 7 describes the default interface-to-zone bindings on an SSG 500-series
device.
Note that the ethernet0/0 interface has the default IP address 192.168.1.1/24 and is
configured for management services. If you connect the ethernet0/0 port on the
device to a workstation, you can configure the device from a workstation in the
192.168.1.1/24 subnetwork using a management service such as Telnet. You can
change the default IP address on the ethernet0/0 interface to match the addresses
on your LAN. There are no other default IP addresses configured on other ports on
the device; you must assign IP addresses to other interfaces.
Basic Device Configuration
The following sections describe the basic configuration tasks required to place an
SSG 500-series device in operation:
 “Admin Name and Password” on page 34
 “Administrative Access” on page 34
 “Interface IP Address” on page 34
 “Management Services” on page 35
 “Hostname and Domain Name” on page 35
 “Domain Name System Server” on page 36
 “Date and Time” on page 36
 “Default Route” on page 36
The examples in this section demonstrate how to establish initial network
connectivity. For advanced configuration information, refer to the Concepts &
Examples ScreenOS Reference Guide.
Table 7: Default Interface-to-Zone Bindings
Port Label Interface Zone
0/0 ethernet0/0 (default IP address is 192.168.1.1/24) Trust
0/1 ethernet0/1 DMZ
0/2 ethernet0/2 Untrust
0/3 ethernet0/3 HA