Hardware manual

80-001113 SysLINK Administrator’s Guide Page 76
&Cn
DCD Control
0=DCD always on
1=DCD follows connection status
(default)
OK(0)
&Dn
DTR Control
0=ignore
1=loss of DTR switches to command
mode and leaves connection open
2=loss of DTR switches to command
mode and closes connection
(default)
OK(0)
&F
&Fn
Load factory default settings
Equivalent to ATZ without dropping
the connection. This command does
not affect the flash configuration for
the port.
OK(0)
&V
&V0
Display S-register values
Ex:
E0 Q1 V0 &C1 &D2
S00:002 S02:043 S03:013 S04:010 S05:008
&V1
Status
Returns reason for the last disconnect:
TERMINATION REASON......DTR LOSS
TERMINATION REASON….CARRIER LOSS
&W
&Wn
Write current configuration to flash
OK(0)
&Xnnn
Change baud rate.
Nnn Baud
3 300
12 1,200
24 2,400
48 4,800
96 9,600
14 14,400
19 19,200
28 28,800
38 38,400
57 57,600
115 115,200
OK(0)
&x
Any other & command is ignored
OK(0)
%x
Any % command is ignored
OK(0)
+x
Any + command is ignored
OK(0)
$xn
Any $ command is ignored
including 0 or more digits after the
command.
OK(0)