Hardware manual

80-001113 SysLINK Administrator’s Guide Page 66
From the Log/Debug page you can also configure the unit to save a dump of system
memory under some circumstances. Scroll the page down to the dump information:
A memory dump may be obtained either manually using the Initiate Dump button on this
page or pressing the reset button or automatically when the unit encounters a catastrophic
error that causes it to reboot. No dump will occur with any of these methods unless the
dump is first configured.
The Device Server IP Address specifies the IP address the unit should use as its own when
initiating a dump. If left blank, the unit uses it’s currently configured IP address. The TFTP
Server IP Address and Filename specify the host and filename on that host to send the
dump to. If the server address is left blank, the unit uses the TFTP server address obtained
from DHCP. The filename must be specified. If any of these parameters are invalid at the
time of the dump, the dump will be aborted. The filename must be that of a writeable file on
the TFTP server. The two IP addresses must be on the same segment (the dump facility does
not support routing). The r4000 utility can be used to configure and initiate a dump. This
utility can also act as the TFTP server for this purpose.