Hardware manual

80-001113 SysLINK Administrator’s Guide Page 11
Refer to the SysLINK Hardware Manual for the effect of the DCE/DTE settings on serial
port pinouts.
For Terminal and Modem ports, the Baud Rate choices also include the modem protocols.
FastConnect reduces the modem connection time by skipping some of the modem
negotiation. If your attached device is designed to connect at 1200 or 2400 you may often
use FastConnect to speed up the negotiation. The High-Speed option is only available on
the dial-backup modem.
Also for Terminal and Modem ports, the following may be configured:
The gateway detects the completion of an incoming dialed number on the Terminal ports
when the digits stop coming in. Set the end-of-dial timeout larger than the maximum time
between dialed digits. Many modems dial with about 70-100 msecs between digits, so a
value of 120-150 works well. The timeout applies to the second and subsequent digits. The
gateway waits a little over 2 seconds for the first digit to timeout to allow for external access
digits (such as 9,1-800…). You may disable this by specifying 0 for the timeout. This will
allow single digit dialing.