User's Manual

Placing the Transmitter into Use
Refer to your existing policy for information regarding when to apply the transmitter to
the infant.
Obtain an Infant ID with Cut-Band transmitter (Part #A20290919) and an Infant ID cut-
Band Strap (Part # C42000913)
Attach the Strap (with base) to the Transmitter. Be sure to attach the base in the
proper orientation.
Test the transmitter using the transmitter tester. (See transmitter testing instructions
for details)
The transmitter should be tested on a daily basis while in use. (see testing documents
attached.)
Route the strap around the infants' ankle.
Pass the strap through the clasp mechanism on the side of the transmitter.
Pull any excess strap through the clasp mechanism. Be sure to leave enough excess
strap to allow for swelling that may occur while not leaving too much to prevent the
transmitter from being slipped off the infants ankle.
Do not cut excess strap. Simply fasten the excess strap to the front of the transmitter
using tape.
Once the transmitter has been placed on the infants ankle, the transmitter ID number
engraved on the transmitter should be recorded in the infants chart and programmed
into the ID Nurse Station. (See programming instructions in the this manual)
insert pictures here for transmitter assembly
and application
7 Manual # A20290691 Rev 0