User`s manual

Motion Sensing Shot



11. Load and Save : Load and save setting values. If you want to save current

parameter values to memory, select one of 3 banks, save1, save2 and save3,

then press the Enter button. If you want to load previously saved parameter

values, select one of 3 banks, load1, load2, and load3, then press the Enter button.

Load1, load2, load3 correspond to save1, save2, save3.



1. Set whether beep sound is produced or not.

2. Pressing the Up button makes the beep sound ON

or OFF in turn.

3. Sound ON/OFF can be set during STOP, PLAY

or PAUSE.



1. Motion sensing shot may not operate in some

combinations of setting values. ERROR is displayed

instead of PLAY immediately after the motion sensing

shot play. Proper parameter values must be set

correctly.

Ex) In the case of 2 exposures per motion sensing, 1 second between consecutive

exposures, and 2 seconds of B shot duration, 1 second of exposure spacing is

too short because 2 seconds of B shot is bigger than it.

20↑00 32↓01 34↑09

Sound OFF Start Method Instant

Error 000000

20↑00 32↓01 34↑09

Sound ON Start Method Instant

STOP 000000