User Instructions

indicator flashes 1 second;
(6) Short press the receiver “VOLUME” button , done;
(7) Then on this receiver to choose a different tone for the other one sensor and following the
above pairing instructions to make them paired is fine.
For example
You bought 2 pack SECRUI M508+D017 door sensor chime. You want to use them in these ways:
1 Receiver + 2 Sensors (equivalent to adding an additional sensor in VARIABLE - tone Pairing
way or in FIXED - tone Pairing way):
Same tones for different sensors
Add an additional sensor in VARIABLE - tone Pairing way
STEPS:
(1) Plug-in the receiver A, long press the receiver A “VOLUME” button until the receiver beeps
once;
(2) Separate sensor and magnetic stripe B once, the receiver will beeps twice with LED indicator
flashes 1 second;
(3) Separate sensor and magnetic stripe B once again, the receiver will beeps once with LED
indicator flashes 1 second;
(4) Short press the receiver A "VOLUME" button, done.
Different tones for different sensors
Reset the receiver first and then pair the two sensors with the same one receiver in FIXED - tone
Pairing way;
STEPS:
(1) Clear All Settings--First unplug the receiver A, then long press and hold "VOLUME" button and
plug in the outlet, you will start to hear continuous beeping and the LED light will flash ten times.
Keep on pressing and holding the "VOLUME button until there is no more sound and light, the
receiver and sensors are now all reset.
(2) Receiver A paired with sensor A
①Press the “VOLUME” button to select a tone that you like;
②Long press the receiver “VOLUME” & “MUSIC” button for about 5-7 seconds until the receiver
beeps once;
③Separate sensor and magnetic stripe once, the receiver will beeps twice with LED indicator
flashes 1 second;
④Separate sensor and magnetic stripe once again, the receiver will beeps once with LED
indicator flashes 1 second;
⑤Short press the receiver “VOLUME” button , done.
(3) Receiver A paired with sensor B -- Choose a different tone for sensor B and following the
above steps.
2 Receivers + 1 Sensor (equivalent to adding an additional receiver in VARIABLE - tone Pairing
way or in FIXED - tone Pairing way):
Refer to VARIABLE - tone Pairing or FIXED - tone Pairing