User's Manual

All Second Wind Air Purification 1000KCS systems have a limited lifetime, (5) year ballast

and 1 year lamp warranty. Second Wind 1002KCS systems have a (3) year unit/ballast and

1 year lamp warranty.

ONE (1) YEAR COVERAGE LAMPS

The 1000KCS and 1002KCS lamps are warranted by Second Wind for a period of one (1)

year from the date of the original installation, when installed and operated in accordance

with Second Wind recommendations. If during this period a lamp fails, Second Wind will

provide a free replacement. You must pay shipping charges and all other costs of warranty

service. Second Wind will not pay labor involved in diagnostic calls or in removing,

servicing, or replacing parts.

UNIT COVERAGE

The covered equipment and covered components are warranted by Second Wind for a

period of (three (3) years-1002KCS) or (Lifetime -1000KCS) from the date of the original

unit installation when installed and operated in accordance with Second Wind

recommendations. If during this period a covered component fails, Second Wind will repair

or replace the part. You must pay shipping charges and all other costs of warranty service.

Second Wind will not pay labor involved in diagnostic calls or in removing, servicing, or

replacing parts.

REPAIRS

All repairs of covered components must be made with authorized service parts. Labor

charges resulting from diagnostic calls or service are not covered by this warranty.

CARE OF EQUIPMENT

Your new Second Wind Air Purifier must be properly installed, operated and maintained in

accordance with the unit installation, operation, and maintenance instructions provided with

each unit. Failure to provide maintenance per Second Wind instructions will void warranty.

1 Do not look directly at the lamps, without UV protective glasses.

2 Read instruction manual before operating the units.

3 Use recommended accessories (i.e. lamps, ballast)

4 Make sure unit is installed so that the UV light can not be seen directly through any returns or supplies.

5 Check damaged parts: Before further use of the unit, any damaged part should be carefully checked to

ensure that the unit will operate properly. Any part that is damaged should be properly repaired or

replaced.

6 Units should not be installed with in 12-18 inches of any non UV resistant materials. If materials are in

question call manufacturer of said products to see if they are made with UV inhibitors. Prolonged UV

exposure will degrade non UV resistant materials. Non UV resistant materials must be shaded or cov-

ered.