Instruction manual

7
Second Wind Air Purifier lamps are designed to be on all the time. After approximately 9000-11000 hours of
operation the lamps intensity will decrease. Installation of a replacement lamp is best handled by a HVAC
Contractor.
1 Turn unit off and unplug the power cord.
After lamp has cooled proceed.
2 Remove Door. (Fig.9)
3 Remove Filter make sure lamp is off.
(Fig.10)
4 Unsecure lamp from brass holder. (Fig.11)
5 Pull lamp out from socket. (Fig.12)
6 Install new lamp into socket and snap into
brass holder.
7 Replace cover plate and tighten latch.
9 Plug unit in and turn on.
NOTE
UV Lamps contain mercury like other
fluorescent lamps and must be disposed of
properly. Do not throw old lamps in the
trash. Contact your local waste collection
agency for proper disposal procedures.
If the lamps are dirty or have fingerprints
on them, use alcohol to remove.