Installation manual

The Second Wind Ultraviolet Germicidal Photo
-
catalytic 24 Volt Lamp is designed for 9000
-
11,000 hours of con
-
tinuous operation. After 9000 hours intensity of the lamp inside the duct diminishes and should be replaced.
Even
if the lamp is still illuminated replacement of the lamp is recommended, by a qualified HVAC Service
Techni
cian.
•
The installation should
be done by a qualified
HVAC contractor.
1.
Disconnect electrical service and turn unit off.
2.
Remove screws from remote lamp connector.
3.
Disconnectthe lamp connectorfrom the lamp
base.
4.
Remove the nuts from the 24 volt lamp bracket
and remove old lamp (Be careful old lamp may
still be hot!).
5.
Replace the old lamp with the new lamp, making
sure the new lamp is clean. If the new lamp is dirty
or has fingerprints on it remove with an alcohol
wipe.
6.
Place RU lamp bracket over newlamp base and
secure with the nuts.
7.
Attach lamp connector to the lamp base and use
nuts to secure.
8.
Turn on electrical service and unit.
UV lamps contain mercury like other househ
old lamps and must be disposed of properly.
State requirements and
recycling opportunities vary, go to
www.lamprecycle.org
for State Regulations & Contacts.
Please contact
your county waste collection department for
proper disposal details.
USE GLOVES AND EYE PROTECTION
If a lamp is broken,
do not use a vacuum cleaner to pick up the waste.
Instead, sweep up the waste into a plastic
bag and seal. Contact your county waste collection department for proper dis
posal details.