Installation manual

•
The installation should be done by a qualified
HVAC contractor. Unit must be installed in com
-
pliance with all national and local electrical and
mechanical codes. Failure to do so will void UL
safety listing and Sec
ond Wind warranty.

Read all safety instructions at the beginning of this
manual. Failure to do so could lead to personal
injury and/or equipment damage.

In cases where molds are already present on the
evaporator coil, it is recommended that a quali
fied
HVAC technician clean the coil before the installa
-
tion of the UV lamp.

Protect all non
-
UV resistant mate
-
rials from direct UVexposure with
aluminum tape or metal conduit.

CAUTION: Ultraviolet light canbe
harmful to your sight, do not look
at the lamp when it is illuminated.
1.
The 24 volt unit should be mounted
in the air handler in a location where
the lamp will have the best UV light
coverage of the coil and drain pan.
2.
The UV lamp is mounted inside the
air handler with a mounting bracket
that is supplied with the unit. Use
the supplied sheet metal screws to
attach the mounting bracket.
3.
Place warning labels (included) on
the duct: one on the duct near the
UV lamps and the
other near the air
handler.
4.
Take the lamp from the box being
careful not hit the lamp against any
-
thing
.
Slide the lamp on to the
mounting bracket or into the UV
shield. Use the supplied nuts to at
-
tach the lamp to the bracket being
careful not to over tighten the nuts.
5.
Wipe lamp with alcohol wipe and
clean cloth after installation proc
-
ess.
Ballast Mounting
1.
The 24 volt ballast should be in
-
stalled near the 24 VAC trans
-
former/control panel. Feed the UV
lamp connection to the
lamp. Screw
the ballast in place with the supplied
screws.
2.
Use the electrical diagram and
connect the ballast to the low volt
-
ageconnectioninaccordancewith
all state and local electrical codes.
3.
Do Not Connect To The High
Voltage Power Source.
4.
Connect the power lead for the lamp
to the lamp connector from the bal
-
last.
5.
Drill hole and insert sight glass, in a
location near the lamp installation.
6.
Re
-
install all panels to the air han
-
dler.
7.
Energize the air handler and check
that the lamp is on,
looking at sight
glass.
Do Not Ever View UV Light
DIRECTLY!